Training in Kassel

Articulation Controls HTCS and ACU

Course duration	1 day on 15.10.2011
Course content Theoretical part	Introduction of the articulation system with the articulation controls HTCS and ACU Functionality of articulation bus/articulation system Functionality of the hydraulic system Function of the electronics: input and output Explanation exemplary on a measured value (e.g. driving speed) Simulation und demonstration Status indicator line to monitor functions using the diagnostic program with the user’s manual Functions test: Fault memory Initialisation
Course content Practical part	Practical demonstration on vehicle Explanation of separate components Functions test: Testing individual in- and outputs Demonstration of throttle reduction Demonstration of damping Demonstration drive: Straight at high speed Straight with lane change Forwards in tight curve Reverse with holding angle Start up on slippery ground
Aim of course	To impart knowledge and skills necessary for maintenance and rectification of minor assembly problems on the HÜBNER articulation system
Target group	Staff from service area who are responsible for fault seeking and repair of articulation systems
Course fee	EUR 280,00 plus VAT per person, including course papers and catering. Notify us by filling in the form or just ring!
Comment	The minimum number of participants for this course is 5 persons. The maximum is limited to 10 persons per course.

Find an authorised HÜBNER Service Partner near you
[more]

25.01.2012
Kassel, Germany
Repair and maintenance
of folding bellows
[more]

13.06.2012
Kassel
Training hydraulic
control device
[more]

17.10.2012
Kassel
Training
articulation control
[more]